CENTRIFUGAL SIMPLE SUCTION IN PLASTIC MATERIAL

354

The ideal use of the PL series is in conveying corrosive fluids, even with high concentrations of moisture. This series allows 12 orientation positions (8 clockwise RD and 8 counterclockwise LG), defined by looking at the fan from the motor side. Suitable for conveying clean, nonabrasive air at a maximum temperature of 60°C

Data sheet

Key Features

  • Molded polyethylene nut
  • High-efficiency backward-bladed impeller made of polypropylene with aluminum hub protected from the conveyed fluid
  • Chair made of epoxy-polyester powder-coated sheet steel
  • Three-phase or single-phase asynchronous motor, efficiency IE2_IE3_IE4, also suitable for operation by speed regulation, protection IP 55 insulation class F, service S1, execution 5, conforms to IEC / EEC specifications

Accessories

- Cerebro and/or Easy series switchboard

Technical characteristics

kW

0,37

Voltage

3PH

Current (A)

1,05

Polarity or No. turns at 1'

Poles 4

Type of controller

QE Cerebro/Easy 1PH Regulator

Dimensions

B x D x H (mm)

600x520x700

Air passage "D" diameter mm

280

Weight KG

34

CIMI Srl reserves the right to change dimensional dimensions and/or performance for improvements or range changes without what is on the site being binding.

The reported data meet the following parameters:

  • - Tolerance on flow rate ±5%
  • - Noise tolerance +3dB(A)
  • - Air temperature 15°C
  • - Barometric pressure 760 mm Hg
  • - Air specific gravity 1.226 kg/m³
  • - Frequency 50 Hz

Sound pressure level was measured by omnidirectional free-field measurement at 1.5 or 3 m (depending on the product) from the fan with ducted inlet, tolerances, performance points and environments according to European standards.

Can't find what you're looking for?

Cta Aspirator