AXIAL RIGHTING

800 1PH

The particular application of the DF series is for air mixing in all those facilities where the phenomenon of de-stratification of heat and humidity is to be eliminated, benefiting the health of the operators and reducing energy waste.
The construction of this series, equipped with adjustable motors at low speeds, prevents the formation of cold air currents on the ground. - Operating temperature : -25°C/+40°C

Data sheet

Key Features

- Wide-radius steel plate drum and diffuser painted with baked epoxy-polyester powders
- Impeller with techno-polymer airfoil blades and aluminum hub, statically and dynamically balanced according to UNI ISO 1940/BS 6861-1 standard
- Fixing chains complete with support bracket
- Three-phase or single-phase asynchronous motor suitable for operation by single-phase speed regulation
- IP 55 protection class F insulation.
It is advisable to install diffusers with speed controllers equipped with a thermal probe or with an automatic control panel, with a temperature set at the thermostat of not less than 20°C in order to avoid the movement of cold air. - Proper installation involves covering the affected area using one destratifier per 200/250 square meters.

Accessories

- Speed controller (single-phase)
- Digital thermostat with probe
- Automatic control panel for speed and temperature control

Technical characteristics

kW

0,14

Voltage

1PH

Current (A)

2

Polarity or No. turns at 1'

650

Type of controller

RV3A

Dimensions

B x D x H (mm)

900X900X200

Air passage "D" diameter mm

800

Weight KG

32

CIMI Srl reserves the right to change dimensional dimensions and/or performance for improvements or range changes without what is on the site being binding.

The reported data meet the following parameters:

  • - Tolerance on flow rate ±5%
  • - Noise tolerance +3dB(A)
  • - Air temperature 15°C
  • - Barometric pressure 760 mm Hg
  • - Air specific gravity 1.226 kg/m³
  • - Frequency 50 Hz

Sound pressure level was measured by omnidirectional free-field measurement at 1.5 or 3 m (depending on the product) from the fan with ducted inlet, tolerances, performance points and environments according to European standards.

Can't find what you're looking for?

Cta Aspirator